Many issues can prevent your Inseego 5G Mifi m2000 device from turning on, or if it does turn on, it does not function properly. Though this is a common problem that can be solved with basic device knowledge, it can be frustrating at times. We have encountered many customer queries on the particular problem and hence listed some ways to troubleshoot the issue. Therefore if your Mifi device also refuses to turn on, this article will guide you through some of the common issues that your Mifi device might face.
Inseego 5G Mifi M2000 Won’t Turn On Fix
1. Battery Issues:
If your device fails to turn on, you should investigate any battery problems it may be experiencing. This problem usually occurs when your battery has reached its capacity and is discharging, preventing the Mifi device from giving enough power to boot up. If this is the case, try replacing your Mifi battery with a new one and see if your device turns on.
2. Correct Type Of Sim Card:
If you don’t have any battery problems, the next thing you should look for is the correct type of sim card. Inseego 5G Mifi devices use Nano sim cards, and the M2000 requires a 4FF Nano Sim card. Remove the device’s cover and battery with care, and then check your sim card. Check to see if your sim card is damaged or broken as well. If so, carefully remove the sim card and replace it.
Another thing to keep in consideration is you should only use a genuine sim card provided by the Inseego provider. In case of damage, contact the provider to send in a new Nano sim card.
3. Firmware Issues:
Your Inseego Mifi device only uses firmware versions that have been verified by the device’s manufacturer. However, if you use unapproved firmware on your device, it may fail to function. So, contact your service provider to walk you through the authorized firmware versions and install the ones that are approved on your device.
4. The Power Button Activation:
Your Mifi device can manually be turned on and off using the power button on the Mifi. Locate the power button on your m2000 Mifi and press it using a paperclip or tools of similar nature. Then hold it for three seconds and then release it. Wait for a few seconds until your device is turned on.
Rebooting helps your devices to work more efficiently by clearing out any accumulated caches and system junks. It temporarily puts your device’s operating system to sleep so when you turn it back on your device performs more effectively.
- Locate the power button on your m2000 Mifi device
- Press and hold it for 3 seconds
- Check the restart button and your device will reboot itself automatically.
6. Contact Inseego:
If none of the above solutions solve your problem, your device likely has a technical problem. Contact your Inseego service provider and request someone to investigate the problem.