Verizon Port Forwarding Not Working (8 Ways To Fix)

The internet has become the most vital part of everyone’s life in the past few years. However, the technology has improved, leading to multiple technicalities as well. In this quest, port forwarding is the network address translation application through which communication requests are redirection from one port to another port.

This will create a traversing of the network gateway through the firewall or a router. However, port forwarding can be complicated. The setup of port forwarding depends on the router, but the configuration can be troublesome. So, if the port forwarding isn’t working out for you with Verizon, we have outlined a range of troubleshooting tips in this article. So, have a look!

Fix Verizon Port Forwarding Not Working

1) Multiple Routers

If you are using more than one router at one time, it can disturb the port forwarding feature. Many users don’t have an idea if they are using multiple routers. However, you can check it by following the below-mentioned steps, such as;

• First of all, login to the router and go to the status page (it will open up the internet and WAN IP address. This IP address should be similar to the IP appearing on the tester page)
• If the IP isn’t same, there are high chances that you are using the local IP address, promising that you are connected to another router
• So, you need to use the other address for logging into the current router
• Go to the DMZ page
• Enable the DMZ after adding the IP address
• Save the settings, and you will be done

2) Wrong IP Address

If the multiple router issue isn’t the culprit of the port forwarding issue, there are high chances that you are using the wrong IP address. The majority of the routers will only provide features to add the last part of the IP address. In contrast, there are some routers that allow users to enter the full IP address. This can create confusion for users. You need to differentiate between LAN and WAN IP address and make sure that you are adding the right correct IP address.

3) Firewall Settings

The modern and advanced routers are integrated with the top-notch firewall options. However, some router does not allow the establishment of a new connection even if the port forwarding is enabled. It is advised to switch off the firewall or establish the minimized settings. This doesn’t put the computer at threat because routers are hardware-based firewalls. So, just optimize the firewall settings, and the port forwarding will start working.

4) Broken Windows Firewall

It’s needless to say Windows is designed with built-in firewalls. However, if the firewall isn’t working properly or is corrupt/broken, there will an adverse impact on post forwarding. This means that there is a WMI issue with the Windows firewall. Even if you’ve switched off the WMI, it can lead to issues in port forwarding. So, you need to fix the issues and promise that all the firewall issues have been resolved.

5) Wrong Connection Type

You will come across a wide range of router that has multiple connection options. You need to make sure that you are connected to the right WAN connection. Also, the right WAN connection and configuration is essential to optimize the IP address. Also, the IP address of the port test page should be entered. So, this combination of IP address and correct WAN connection will positively impact the port forwarding.

6) Computer Name

While conducting port forwarding, you need to offer the computer name, irrespective of the modem or router. However, there are chances that your computer name is added to the router multiple times, and each name will direct to the different IP addresses. So, make sure you are choosing the right computer name, so the IP address direction will be a correct, thus positive impact on the port forwarding.

7) Same Port

The majority of the routers don’t have port checks to see if the port forwarding rule is working or not. It’s essential to note that one port can only forward one IP address at a time. So, if there are multiple port numbers in the router, port forwarding will not work. All in all, add the single port number for port forwarding to work.

8) DMZ

If the DMZ is enabled, you will have a hard time conducting post forwarding. This is because enabled DMZ will open the ports, leading to connectivity issues. So, disable the DMZ right away!