One of the first things that people have to do to access the internet in their homes is to find an ISP. Once done, they can then select a package and get a connection set up at their house. The main problem with stock modems is how low their signal range is. Considering this, if you want to use WI-FI in your house then you should purchase a new router. This is where the TP-Link Archer C7 comes in. The router has tons of features on it that ensure its users can stay comfortable when using it. However, there are also some problems that they can run into with this device. One of the best ways to fix most of these issues is by resetting the router back to its factory default settings. This is why we will be using this article to teach you how to factory reset the TP-Link Archer C7.
How To Factory Reset TP-Link Archer C7
1. Using The Factory Reset Button
The reset method is usually the same for every router with the only exception being the position of the button. This is why you will first have to find the reset pinhole on your device which should usually be behind it. Once done, you can now find a small pin that will be used to press this button.
Hold the pin inside the button while your router is switched on and wait for a few seconds. You will notice that all of the lights on your device now start blinking which indicates that it is now being reset. Wait patiently while the device is going through this process after which the lights should become stable. You can then start using your TP-Link Archer C7 again without any further problems.
2. Soft Resetting Your Network
The main problem with a factory reset is that it removes any changes that you had made to the device. Considering this, people will have to set up their router from scratch which can be quite annoying. Instead of this, another process that you can try is a soft reset.
This also helps in removing most configuration errors on your network as long as you do it properly. Start by removing the power cable for your router and then the modem. Now wait for a few minutes and plug your modem back in. Once it becomes stable, you can then start your router and see if the problem is fixed.
3. Router Might Be Damaged
The steps mentioned above should be enough to fix any software-related problems with the TP-Link Archer C7. Although, if you are still getting the same issue then you can try updating the firmware for your router. Aside from this, a better solution that you can go with is contacting the support team for your device.
This is because there is a high chance that your problem might be from a hardware error instead of a configurational issue. Considering this, provide all the details required about your problem to the support team so that they can help you out.