When it comes to choosing a broadband device, NETGEAR devices are one of the most dependable options. Aside from all of the personalized features that these devices provide, their interactive hardware interface is noteworthy. The NETGEAR EX3110, in particular, has several LED lights that indicate the status of the device’s connection.
Having said that, these LEDs can be extremely useful in diagnosing a problem with the extender. Among other LED issues, the EX3110 device light not turning on is a frequently asked question by users. As a result, we’ll go over some troubleshooting steps for the problem.
NETGEAR EX3110 Device Light Not On Fix:
- Power Cycle Your Extender:
No device light on your NETGEAR extender indicates that no device is currently connected to your extender. Some extender software updates are downloaded but not installed till the extender reboots. It’s conceivable that your extender’s behavior is the result of an incomplete software installation that needs to be finished. As a result, rebooting your extender will help in the installation of unfinished software.
To reboot your extender, disconnect all the cable connections including the power adapter. Disconnect the extender from a power source and wait until 30 seconds. Connect all the cables one by one and make sure they are hand tight and placed into their respective ports. Wait till your extender has stabilized.
- Check Extender’s Connection With The Router:
Your extender, as the name implies, extends your existing network connection, which means it must be linked to your Wi-Fi router to operate normally. When the device light on the extender illuminates, you have confirmed a client connection. If your devices identify but do not connect to your extender network, you must check your router-extender connection.
Inspect your router and extender connections, and make sure your cables are tight and in good working order. Disconnect the cable and reconnect your router and extender if required. When connecting your extender to the router, ensure that the cables are securely embedded into their respective ports and that the LED light on your extender illuminates.
- Set Your Extender Via WPS:
The WPS button indicates that a connection has been established. It means that your extender is identifiable by nearby clients and can communicate with them. If the device lights do not turn on after you have completed the preceding steps, try configuring your router using the WPS button.
Locate and press the WPS button on your NETGEAR EX3110. The WPS LED should start blinking. Now press the WPS button on your router, but you must do so within two minutes. Your extender and router will now be connected. When the connection is established, the WPS light will turn static green, and the Router LED on your extender will illuminate.
- Reset Your Extender:
To resolve the connection issue, reset your extender to its factory settings. With a paper clip or similar object, press and hold the reset button on your extender until all of its lights turn off. Wait until the power LED turns amber and your extender restarts. Your extender has been reset to its factory settings.