Sanyo is a Japanese brand that mainly focuses on manufacturing television for its users. They have a huge lineup to select from. All of their products have different services that come along these. Though, you should note that there is no single device that will have all the features. This is why you must go through their specifications before deciding on purchasing a single one.
This will help you in finding the best television to use at your home. You can watch movies as well as stream shows without any difficulty. While these are easy to use and have great durability. Some people have reported that their Sanyo TV won’t turn on after a power outage. If you have also been getting this problem then here are some simple steps that should help you out.
Sanyo TV Won’t Turn On After Power Outage
- Reset Television
Power outages can cause system failure for most devices. Keeping this in mind, the configuration files for your system might have gotten corrupt during this. The best method to get rid of this is by resetting the device. The procedure gets rid of most issues regarding the settings on the system to fix any problem that you were getting. This will also bring your device back to its factory default state so remember that. You can begin by powering off the device.
Now remove the main power cable from your device and disconnect any other wires. Once the connection for your device has been completely cut off, you can then finally proceed to reset it. Hold down the power button on your device for a few minutes. Usually, 45 to 60 seconds are more than enough but do not go lower than this. You can then plug in the power cable to switch on your device. The red light will become stable and you can then switch on your television to start using it.
- Check Wall Outlet
If you notice that there is no light blinking on your television. Then your outlet might have fried out. This is quite a common problem during power outages. The current coming to your connection can fluctuate during this which will give you similar problems in return. The only method to fix this is by checking the status of your sockets.
Usually, a voltmeter is required which can easily be purchased from an electronic store. You can plug it in your outlet to check the reading of current coming from it. If the socket is completely dead then check if it uses fuses in it. Replacing these will fix the problem you were getting. IF the connection does not use a fuse then it will require a complete replacement. People who do not have access to a voltmeter can use any lamp in their home instead. You can tell the state of current values by observing the bulb.
If the light is blinking then-current might be too low. However, if it is completely off then the socket is completely dead. It is recommended that you contact a specialist when replacing the outlets to ensure there are no errors. The procedure can be dangerous for people who do not know how these can be replaced. Lastly, you should be able to continue using your television using an alternate outlet during this timeframe.
- Faulty Motherboard
If none of the fixes mentioned above work for you then your only option will be to get the motherboard replaced. It might have burnt out during the power surge and there is usually no way to fix it. Another thing to keep in mind is that the company does not offer any replacements for their motherboards. You can try to contact them and ask if they have any left in stock.
Though, if they do not then you will have to try and get the board repaired. Many electrical stores offer repair services. But it is highly unlikely that you will get the main board fixed. Your only option, in this case, will be to purchase a new television. Considering this, it is better if you select a brand with more versatility. This will allow you to get a warranty and ensure that most of your problems will be fixed by customer support.