The internet is an amazing service that provides people with numerous options. You can play games on it or listen to music when you are bored. Alternatively, people can even watch movies and subscribe to different packages. These allow you to get additional features that you did not have access to previously.
Though, under work situation, one of the best things that this service provides you with is setting up a LAN network. These are privately owned networks that allow you to connect all of your devices. These include scanners, printers, and even servers. The user can then send information and data between these devices to speed up their workflow.
Talking about LAN networks, the user has to set up these through the use of some equipment. These are essential and will also ensure that you do not run into any problems. Talking about this, one of the best companies that provide people with these products is Cisco Meraki.
This is an IT company from California that uses cloud management services and also manufactures tons of hardware equipment for these networks. If you are thinking about setting up a LAN network then it is most likely that you are already aware of this company. They have some of the best switches and routers that you can set up for your network.
This Device Is Using A DHCP IP Address from VLAN 0 Instead of Using Configured VLAN 1
When setting up your Meraki network switches, the user must follow all the instructions provided by the company. These are made to make the process easier for people as well as to ensure that there are no problems. Though, it is quite common that you make a mistake during the configuration steps.
Considering this, one of the most common errors that people run into is the following ‘This Device Is Using A DHCP IP Address from VLAN 0 Instead of Using Configured VLAN 1’. This usually, indicates that there is a problem with your configuration which needs to be dealt with. One reason can be that the static IP address that you have provided to the network is not accurate.
This can cause the system to try the connection a few times after which it will connect to the standard VLAN 1 instead. Considering this, the user should look into the address again and ensure it is correct. You can even check if the ports you are trying to configure all carry VLAN in the same way you are intending to. If these are not then configuring those as well to fix your issue.
You can also search online to find a few guides that can help you with this procedure. Though, if you have checked these settings and all of them are set up correctly for you. Then the only reason why you might be getting this error can be that you have also set up a port on your AP. Usually, when trying to use a static IP, the user has to only set their VLAN switch to 10 and then leave out the AP as blank. This will most likely help you in getting rid of the problem.