4 Troubleshooting Tips For Asus ROG Rapture GT-AX11000 Red Light

asus rog rapture gt-ax11000 red light
asus rog rapture gt-ax11000 red light

If we look at the Asus router range, it wouldn’t be wrong to say that GT-AX11000 is one of the best Wi-Fi 6 routers available out there. This is a promising gaming router with top-notch internet throughput and a high-end internet connection. The router is integrated with a tri-band configuration to support multiple devices simultaneously without causing any internet issues. However, seeing an Asus ROG Rapture GT-AX11000 red light is a common issue that indicates a slow or no internet connection. So, let’s see how this red light can be turned into green light!

Asus ROG Rapture GT-AX11000 Red Light

1. Just Wait

To begin with, it’s suggested to wait for a while before you start the troubleshooting guide. This is because the light could be red because the router is upgrading its firmware, and the firmware upgrade shouldn’t be interrupted. If the router is showing red light because of the firmware upgrade, the light will turn green or yellow within a few minutes. However, if the light remains red even after an hour, you can start following the troubleshooting steps outlined below!

2. Check The Router Connections

The loose connectors or damaged cables can lead to a red light on your router. For instance, even if one cable is damaged or not connected to the designated router, you will see a red light. In the majority of cases, the users disconnect the wires for a reboot but don’t reconnect the wires/cables tightly enough. So, you must check behind the router and make sure the cables are tightly connected to the right ports (ports are also important). You can also read the manual to check if you have connected the wires to the right ports.

The second potential issue with the wires is the internal damage. Usually, the cables get damaged when they are bent too hard, and replacing them will be the only solution. So, check the cables for abnormal bends and damages and replace them on time.

3. Power Strip

It’s common for people to use power strips and surge protectors to make sure the devices are protected from voltage fluctuations, but it can also restrict the power connection. For this reason, it is better that you disconnect the power strips or surge protectors from the router connection and try using the internet again. However, you should reboot the router after disconnecting the power strip or surge protectors.

4. Reboot

Rebooting the router is one of the best solutions to fix the red light and optimize the internet connectivity. To reboot your router, you have to disconnect the power cord and leave it off for a few minutes. Afterward, just plug the router’s power cord again and wait for it to boot up completely. After a minute or two, the white light of the router will turn into green light, promising a stable internet connection.

The bottom line is that these are a few steps that you can try. However, if the router still has a red light, you will need to connect with Asus customer support or your internet service provider to get more assistance.

Leave a Comment