When it comes to ultra-fast, dependable connections and high-speed internet, Amped wireless is a great option. Their routers provide excellent coverage and signal strength, which improves overall network performance.
However, these devices may be vulnerable to certain issues. However, one of them is connection and performance issues. These issues are caused by relatively simple influences, and resolving them is not that difficult unless you are facing a hardware failure. So, if your Amped wireless router is not working, we’ll show you how to fix it in this article.
How To Fix Amped Wireless Router Not Working?
- Check You Cabling:
Bad cable connections are one of the causes of poor network performance. Though it may appear to be a minor issue, it can cost you a lot of time trying to figure out what went wrong. Because your modem is in charge of sending internet to your router, you should start by checking the modem cable. Check that the Ethernet cable is not damaged and is securely seated in its port. Remove and reconnect the wire. When you complete the connection, the respective LED lights should light up.
- Reboot Your Modem And Router:
Rebooting your modem and router can help you with certain errors that are minor but result in a poor connection. As a result, begin by rebooting your modem. Make sure that the cable connecting both is disconnected. After a few seconds, disconnect the modem from the power supply and reconnect it. Allow time for the modem to stabilize.
Now, remove your router from the power adapter. Allow it to rest for about a minute before reconnecting it to the power supply. Turn on the router and wait for it to settle. Connect an Ethernet cable to the modem now. Make sure the connection is secure. Connect to your network and check to see if the internet is operational.
- Connect Directly To The Modem:
If you are unsure of the source of the problem, connect your device directly to the modem. Launch a web browser and check to see if the internet is operational. If this is the case, the issue could be with your router. A factory reset can help to narrow down the causes.
- Factory Reset:
When nothing seems to work on the router, a factory reset is a good option. Hold the reset button on the back of the router for about 10-15 seconds with a paper clip. Wait for the router to reboot before restoring it to factory settings. Configure your network’s SSID and connect it to the devices. If the connection has been established thus far, it is satisfactory. However, if the devices fail to recognize the network, there must be a hardware problem.
- Contact Amped Support:
If you haven’t been able to resolve the problem by this point, your Amped wireless router is most likely experiencing a hardware malfunction. As a result, it is best to seek professional assistance. You can explain your problems to the Amped technicians, and any hardware-related issues will be resolved.