The powerline adapter networks have gained immense popularity among wired internet users because it helps extend the network to make sure there is seamless internet connectivity in every corner of the house. However, if you are using the Netgear adapter and have a Netgear Powerline 1000 pick-a-plug red light issue, let’s check out the easiest solutions that you can try!
Netgear Powerline 1000 Pick A Plug Red Light Fix
The red light on the powerline adapter means that the link rate is slow, which reduces the internet throughput speed as well. To turn this red light into green light, check out the following solutions;
1. Electrical Outlet
The first solution is to rethink the electrical outlet that you are using to connect the Ethernet adapter because it must have enough power voltage to support the adapter’s performance. For instance, if there are low voltages in the electrical outlet, it won’t power the adapter, resulting in red light. The solution is to change the electrical outlet where the voltage is good enough. Once you connect the adapter to a new electrical outlet, it promises a faster internet connection (or should we say high-speed link rate?).
2. Ethernet Port
In case you have tried changing the electrical outlet of the adapter, you must check the Ethernet port. That’s because if the Ethernet port stops working, it won’t be able to optimize the network connectivity or signal reception. So, if your powerline adapter has two Ethernet ports, we recommend that you use another Ethernet port to improve the link rate.
3. Components
The third solution that you can try is to inspect the network connection and power connection because extra components can result in speed issues. For instance, if you have connected the extension cords, power strips, and surge protectors on the network, you must remove them and try connecting the powerline adapter again. That’s because these extra power devices can interfere with the internet-based equipment’s signals, resulting in link rate issues. So, remove these components!
4. Outdated Software Or Hardware
If you are using the Netgear Powerline 1000, but the link rate is slow, you must be extremely careful about the hardware. For instance, if the internal wiring or fuse boxes are dated, it’s likely to slow down the connection and result in slow performance. So, check the hardware and repair/replace the damaged parts of the hardware. Secondly, you must ensure that the powerline adapters have the latest software version installed and that the configuration settings are correct.
5. Network Interference
Another solution is to check the network interference. For instance, if you connect a high-end electronic device around the powerline adapter, it results in frequency issues, resulting in network interference. That being said, disconnect the extra electronic devices, and it will help minimize the interference
The Bottom Line
Netgear Powerline 1000 is one of the best Ethernet powerline adapter kits available on the market, but it’s susceptible to network errors just like other internet equipment. However, these solutions are likely to resolve the red light, but if the LED indicator is still glowing red, you must call your Netgear customer support!